Water in your iphone – repair

The iPhone spilled tea or coffee
The iphone was spilled with tea or coffee
Do you want tea or coffee? With sugar or without? If you need to clean the iPhone, then it’s better without sugar, and if coffee, then without milk. More harm to the device is caused by coffee. Coffee leaves a characteristic smell and contains coffee crumbs. Milk aggravates the case and leads to rapid mold formation. Tea with sugar is also unpleasant for removal because of the sticky layer. However, the chance of restoring the device after getting tea or coffee is big enough.

The iPhone spilled engine oil
This is a rather rare case that was in my practice. I decided to remember about it because there are other oil-containing fluids in the stern of engine oil. In the case of machine oil, cleaning was very difficult. But the damage to the motherboard and peripheral elements was not at all. The spots remained only on the display, it had to be replaced. If your device is in a greasy environment, then cleaning can not be simple, but expecting a successful outcome is still worth it. Oil with water is not friendly. Want to know more ?

The iphone was spilled with milk or kefir
In that case, much depends on you. As in other variants, the speed of service calls in the first place, but it is when milk, kefir, yoghurt comes in that customers address too late. This is because you can not simply assess the level of danger. The case, at first glance, can be quite intrepid and many strains of milk generally do not notice the problems in the operation of the device. This is due to the fact that the viscosity of milk, kefir or yogurt is high enough. By experience, I can say that I have not seen a completely submerged device in milk. The liquid spreads unevenly and more likely locally.

If you immediately clean such a site, then there will be no problems. But if you do not, then all dairy products very quickly form mold and start the process of fermentation in a humid environment. If you dried the device, then an organic crust is formed on the elements of the board. Clear it is extremely difficult. Often this leads to damage to small elements, capacitors, resistors, coils, etc. And, in the long run, it threatens to rotten the contacts on the board.

Leave a Reply

Your email address will not be published. Required fields are marked *